Bitspower NJORD II 140 PWM Fan Digital RGB

Looking for a powerful and stylish fan? Bitspower has what you need with the Bitspower NJORD II 140 PWM Fan Digital RGB. With a maximum speed rate of 1500RPM, which can be adjusted via the supported PWM, the 140x140x25mm fans are best suited to be paired with the Bitspower radiators for efficient cooling. Equipped with vibration cancelation rubber pads on all four corners, no rattling noise will be disturbing your surrounding while you game, stream, watch a movie or work.

RGB enthusiasts will be pleased to know that the Bitspower NJORD II 140 PWM Fan Digital RGB feature Bitspower Digital RGB LEDs around the center shaft for the best light effects. In addition to give you the possibility to daisy chain the RGB interface of your fans, Bitspower also made sure to have them  certified by ASUS AURA Sync, GIGABYTE RGB Fusion 2.0, MSI Mystic Light Sync, ASRock Polychrome, and Razer Chroma to ensure a synchronous lighting of your system.

Included :
1pcs of BPTA-NJORD140-DRGB
 

Rated Voltage: Fan DC12V /LED DC 5V
Operation Voltage:  DC 8V-13.2V (Max.)
Staring Voltage: ≤DC 8V
Fan Speed: 600~1500 RPM±10%
Noise Level: 25~35dBA(Max)
Life time:30000 Hours
No.of Blades: 11 leaves

Dimension(LxWxH) : 140x140x25 MM

If there aren’t enough DRGB headers on the motherboard, you can use the "Bitspower Digital RGB Multi Function Controller", which is available for purchase via the link below:
https://shop.bitspower.com/index.php?route=product/product&product_id=7822

I wanna show off, but what's the support I'd need?

◆DRGB

The end of power supply is 3PIN. The sequence is +/D/↓ (some motherboards are shown +5V/D/↓, and the plug is like 4PIN but the 3rd PIN is empty). Please plug in the corresponding direction of motherboard, controller or the wire integrator for one to many. If choosing the motherboard as the power supply, the light effect can be synchronize with MB.