Bitspower Pre-bent 90-Degree Acrylic Hard Tube
During the building of a water-cooling system, bending tubes successfully often requires a high degree of experience and craftsmanship. It was with this in mind that Bitspower's developed our Pre-bent 90-Degree Acrylic Hard Tube, making building a new rig easier for water-cooling novices and experience builders alike. The acrylic tube has been curved at a 90-degree angle, the 90-degree angles with additional straight tubing of 220mm and 305mm on either side of the bend. The customer can simply cut the tubing to the appropriate length and install it in their water-cooling system.
Length : 220x305mm
4 pcs of Pre-bent 90-Degree acrylic Hard Tube OD16MM
Dimension(LxWxH) : 220x305xø16 MM
If there aren’t enough DRGB headers on the motherboard, you can use the "Bitspower Digital RGB Multi Function Controller", which is available for purchase via the link below:
I wanna show off, but what's the support I'd need?
The end of power supply is 3PIN. The sequence is +/D/↓ (some motherboards are shown +5V/D/↓, and the plug is like 4PIN but the 3rd PIN is empty). Please plug in the corresponding direction of motherboard, controller or the wire integrator for one to many. If choosing the motherboard as the power supply, the light effect can be synchronize with MB.